NEWS

In-mold Label for Blow Molding

In-mold Label for Blow Molding

XIANG-IN always committed to developing In-mold label for blow molding bottle products because it meets environmental protection requirements and could reduce the cost of recycling. And the material for this kind of label are always monopolized by a Japanese manufacturer-Yupo Corporation.
However, due to the cost of raw material rising, COVID-19 pandemic and shipping delay and other unstable reasons that most of current manufacturer who always take the material from Yupo often meets the problem of serious delay of the lead time and rising cost.

XIANG-IN has been focused on this issue for a long time and spent lots of time on developing the same label material as Yupo manufacturer made.
Finally, we successfully made the same kinds of label material for blow molding bottle injection in May, 2022 Taiwan.
The adhesion of label we made are also better and price is much lower than Yupo.
In addition, using our label could reach less than 3% defective rate.
We think these advantages can greatly reduce the cost of production and improve client's competitiveness.
This spirit and principle of operation are also what XIANG-IN always been pursued.

top